Remove/Install Loudspeaker In Instrument Panel - AR82.62-P-7833GQ

MODEL 166, 292 

Shown on MODEL 166 with CODE 220 

(PARKTRONIC) 

Fig 1: Loudspeaker In Instrument Panel Components Location - Model 166 (Shown With Code 220)

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Switch on ignition and store transmitter key outside of transmission range (min. 2 m)
2	Carefully unclip cover (2) at rear edge (arrow and pull upward out of installation opening	Insert cover (2) first with both front tabs, then clip into place at the rear of the clamp. Long wedge	Fig 2
3	Disconnect electrical connectors (3) at cover (2)
5	Pull center instrument panel speaker (H4/27) upward out of instrument panel	Ensure that the rubber mounts (5) are correctly seated in the instrument panel. Mounting wedge	Fig 3
6.1	Disconnect electrical connectors (4) from center instrument panel speaker (H4/27)	MODEL 166
6.2	Disconnect electrical connector from center instrument panel speaker (H4/27)	MODEL 292
7	Remove center instrument panel speaker (H4/27)
8	Install in the reverse order

Fig 2: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA