LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2017 >> GLS63 AMG >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Electrical System - Body - 166 Chassis 5 Of 8 >> Testing & Repair >> Remove/Install Keyless Go Antenna - AR82.62-P-8000GQ

Remove/Install Keyless Go Antenna - AR82.62-P-8000GQ

Model 166, 292 

with code 889 (KEYLESS-GO) 

MODIFICATION NOTES

19.01.2021 Method for model 166.063 added. Operation step 2.5  

Illustrated on model 166.0 

G14137112Courtesy of MERCEDES-BENZ USA

Shown on model 166.8 

Fig 1: Keyless Go Antenna Components Location - Model 166.8 With Code 889
G14137113Courtesy of MERCEDES-BENZ USA
CAUTION Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.
AS00.00-Z-0017-01A
Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
REMOVINGINSTALLING Remove/install     
1 Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).    
2.1 Remove center console. Model 166.0, 292 with code 889 (KEYLESS-GO)
When removing vehicle interior KEYLESS-GO antenna (A2/61).
IMPORTANT Model 166.0, 292 with code 301 (Ashtray package) with code 889 (KEYLESS-GO)
The vehicle interior KEYLESS-GO antenna
(A2/61) is located below the ashtray.
AR68.20-P-2000GQ
2.2 Remove center console. Model 166.8 with code 889 (KEYLESS-GO)
When removing KEYLESS-GO center console (A2/60).
IMPORTANT Model 166.8 with code 301 (Ashtray package) with code 889 (KEYLESS-GO)
The center console KEYLESS-GO antenna (A2/60) is located below the ashtray.
AR68.20-P-2000GQ
2.3 Remove door lining from the rear door. When removing left rear door KEYLESS-GO antenna (A2/39) or right rear door KEYLESS-GO antenna (A2/41).
Model 166 with code 889 (KEYLESS-GO) except code Z04 (Light armoring) except code Z05 (B5 armoring on special protection version)
Model 292 with code 889 (KEYLESS-GO)
AR72.12-P-1010GQ
2.4 Remove load compartment floor. Model 166.0 (except 166.063), 292 with code 889 (KEYLESS-GO)
When removing trunk KEYLESS-GO antenna (A2/35).
 
2.5 Remove high-voltage battery module (A100). Model 166.063 with code 889 (KEYLESS-GO)
When removing trunk KEYLESS-GO antenna (A2/35).
AR54.10-P-1140GQA
2.6 Release front trunk floor until trunk KEYLESS-GO antenna (A2/35) is accessible. Model 166.0 (except 166.063), 292 with code 889 (KEYLESS-GO)
When removing trunk KEYLESS-GO antenna (A2/35).
IMPORTANT The trunk KEYLESS-GO antenna (A2/35) is located under the backrest of the larger rear seat.
 
WARNING Risk of injury.  Moving parts can pinch, crush or, in extreme cases even sever extremities. No parts of the body or limbs should be within the operating area of mechanical components when moving components. AS00.00-Z-0009-01A
2.7 Fold both rear seats of 2nd seat row forward. Model 166.8 with code 889 (KEYLESS-GO)
When removing vehicle interior KEYLESS-GO antenna (A2/61).
 
2.8 Remove covers (1, 2) and lift floor covering. Model 166.8 with code 889 (KEYLESS-GO)
When removing vehicle interior KEYLESS-GO antenna (A2/61).
 
3 Release and disconnect corresponding electrical connector.    
4 Remove nuts (4). Model 166.8 with code 889 (KEYLESS-GO)
When removing vehicle interior KEYLESS-GO antenna (A2/61).
 
5 Unclip corresponding KEYLESS-GO antenna (A2/35, A2/39, A2/41, A2/60 or A2/61).    
6 Install in the reverse order.