Retrofit Screen - AN82.60-P-0013-02GQ

Model 166 

with code 866 (Pre-installation for Rear Seat Entertainment System) 

1. Position template (1), as shown, on backrest.
2. Mark cutting area (2) on backrest cover.
3. Remove template (1).
4. Cut backrest cover and foam material of backrest at front along cutting line (2).

   Be very careful when cutting.

   Otherwise the backrest cover may be damaged in what will later be the visible area.

   Courtesy of MERCEDES-BENZ USA

5. Unhook flap (11) from backrest cover on front seat backrest frame.
6. Guide 8-pin connectors (12) through cutout in backrest cover.

   The 8-pin connectors (12) are fixed in place with duct tape on the front seat backrest frame.

   Courtesy of MERCEDES-BENZ USA

7. Position screen bracket (13) together with reinforcement (14) on the front seat backrest frame.

   Carefully guide screen bracket (13) together with reinforcement (14) through backrest cover (16).

   Otherwise the backrest cover (16) may be damaged in what will later be the visible area.

8. Screw in screws/bolts (15).
9. Slip flap of backrest cover (16), created when the backrest cover (16) was cut, inwards.

   Courtesy of MERCEDES-BENZ USA

10. Secure left rear display (A40/5) or right rear display (A40/6) using screws/bolts (17) to screen bracket (13).

    Courtesy of MERCEDES-BENZ USA

11. Connect 8-pin connectors (12) to left rear display (A40/5) or right rear display (A40/6).
12. Install cover (18).
13. Hook in flap of backrest cover at front seat backrest frame again.

Courtesy of MERCEDES-BENZ USA