Remove/Install Xenon Bulb With Integrated Ignition Module - AR82.10-P-4636GQ
Model 166 with code 615 (Bi-xenon headlamps with active light function) with code 621 (Intelligent Light System (left-hand traffic)) with code 622 (Intelligent Light System)
Shown on xenon bulb, left side
Fig 1: Xenon Bulb With Integrated Ignition Module Components Location - Model 166 With Code 615, 621, 622 (Shown On Left Side)
| Remove/install | |||
| Risk of death when working on component parts and systems with U ≤= 30 V alternating voltage (AC) or U ≤= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines. | AS00.00-Z-0035-01A | |
| Risk of explosion/risk of fire caused by highly flammable materials in the vicinity of damaged xenon bulbs. Risk of injury caused by UV light, hot components on xenon headlamps and glass splinters produced by bursting xenon bulbs. Risk of poisoning caused by inhalation of mercury vapors and by swallowing of/skin contact with toxic salts and mercury compounds. | Do not touch parts conducting high voltage. Persons with active electronic implants (e.g. cardiac pacemakers) must never work on xenon headlamps. Switch off the entire lighting system. Wear insulated safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the danger zone. Ensure sufficient ventilation in the working area. | AS82.10-Z-0001-01A | |
| 1 | Switch off ignition and remove transmitter key or KEYLESS-GO stop/start button from the EZS control unit | ||
| 2 | Lift vehicle on vehicle lift | AR00.60-P-1000GZ | |
| 3 | Open service flap (1) in left or right front fender liner | ||
| 4 | Turn cap (2) of left or right front lamp unit counterclockwise and remove | ||
| 5 | Remove xenon bulb with integrated ignition module (E1e10) or (E2e10) from reflector | ||
| 6 | Install in the reverse order |