Remove/Install Tail Lamp Unit - AR82.10-P-4731GQ
Model 166.8 as of model year 2016
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch on ignition and store transmitter key outside of transmission range (min. 2 m) | ||
| 2 | Remove trunk stowage compartment at left or right | ||
| 3 | Unscrew nuts (4) | ||
| 4 | Pull out left rear lamp unit (E3) or right rear lamp unit (E4) until electrical connector (3) is accessible | ||
| 5 | Disconnect electrical connector (3) and remove left rear lamp unit (E3) or right rear lamp unit (E4) | ||
| 6 | Install in the reverse order |