(Remove/Install Trim At C-Pillar - AR68.30-P-4490GQS)

MODEL 166 (except 166.8) 

with CODE Z05 (B5 armoring on special protection version) 

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove edge guard (3) on interior paneling (2) from C-pillar
2	Unscrew bolt from belt end fitting at bottom	Bolt, belt end fitting/seat belt lock, rear seat on body/seat	*BA91.40-P-1007-01R
3	Unclip interior paneling (2) from C-pillar on side wall	Make sure that retaining clip (4) is seated properly. Guide interior paneling (2) into headliner free of tension. Do not twist seat belt.
		Mounting wedge	Fig 1
4	Remove side paneling in trunk		AR68.30-P-4800GQ
5	Unclip trunk paneling (1) from C-pillar on side wall	Install guide lugs (5) into C-pillar paneling free of tension.
		Mounting wedge	Fig 1
6	Install in the reverse sequence

Fig 1: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA