LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2017 >> GLS550 >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Wheels, Chassis Alignment Check - 166 Chassis 1 Of 2 >> Testing & Repair >> (Remove/Install Wheels - AR40.10-P-1100GQC)

(Remove/Install Wheels - AR40.10-P-1100GQC)

Model 292 

G14136435Courtesy of MERCEDES-BENZ USA
DANGER Risk of death  caused by vehicle slipping or toppling off of the lifting platform. Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. AS00.00-Z-0010-01A
Notice  Information on tires/rims   AH40.10-P-9411-01A 
REMOVING Remove     
1 Lift vehicle with vehicle lift.   AR00.60-P-1006A
2 Remove hub caps. Only for vehicles with hubcaps.  
3 Unfasten wheel bolts and remove wheels using wheel lift dolly. NOTES
Remove complete wheel only with wheel lift.
Otherwise, the brake disks and wheel and tire assemblies may be damaged.
 
INSPECT Check     
4 Check condition of tires.    
REFER TO MAINTENANCE     AP40.10-P-4051EW
5 Clean components of bolted wheel connections, check them and protect against corrosion.   AR40.10-P-1100-02A 
Paste, hot lubrication 1 kg, DBL 6879.20 *BR00.45-Z-1005-06A 
INSTALLING Install     
6 Swap over the wheel and tire assemblies on the front and rear axle. On vehicles without mixed tires.
NOTES
Note running direction of wheel-and-tire assemblies.
Otherwise, handling characteristics and handling comfort may be impaired and tire wear increased.
IMPORTANT If necessary, swap over wheel and tire assemblies subject to separate repair order.
 
7 Use wheel lift dolly to mount wheel and tire assemblies then tighten wheel bolts. NOTES
Mount complete wheel only with wheel lift. Otherwise, the brake disks and wheel and tire assemblies may be damaged.
IMPORTANT Observe the tightening sequence (1 to 5) and tightening torque.
 
TORQUE SPECIFICATION Wheel bolt *BA40.10-P-1001-01J 
8 Lower vehicle.   AR00.60-P-1006A
9 Correct tire pressure of tires on front and rear axle.    
REFER TO MAINTENANCE   If unusual tire pressure loss occurs,

determine cause and correct.
IMPORTANT After obtaining special order.
AP40.15-P-4061A
10 Remove hub caps. Only for vehicles with hubcaps. NOTES
Check hubcaps are correctly positioned relative to valve and that it is securely seated. Otherwise the valve will be damaged or the hubcaps will be lost.
 
11.1 Restart tire pressure monitor (TPM). Model 292 with code 475 (Tire pressure monitor (TPM)) Only for wheel-and-tire assembly change, tire replacement or a change in tire pressure. AR54.30-P-1001-01GQC
11.2 Activate tire pressure loss warning system. Model 292
except code 475 (Tire pressure monitor (TPM))
Only for wheel-and-tire assembly change, tire replacement or a change in tire pressure.
 
WHEELS

Number Designation Model 292
BA40.10-P-1001-01J Wheel bolt Nm 150
REPAIR MATERIALS

Number Designation Order number
BR00.45-Z-1005-06A Paste, hot lubrication 1 kg, DBL 6879.20 A 000 989 76 51