Lift/Jack Up Vehicle - AR00.60-P-1000GZ
MODEL 164, 166, 292
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of accident caused by vehicle starting off on its own when jacked up. Risk of injury caused by rotating parts when working on running engine or drive train. | Ensure that jack stands are in a safe condition. An authorized person must occupy the driver's seat. Wear closed and close-fitting work clothes. Do not touch hot or rotating parts. |
AS00.00-Z-0008-01A | |
| Raise vehicle | |||
| 1 | Align vehicle between vehicle lift columns | ||
| 2 | Install complete adapter set on vehicle jack support points | Only when the underfloor paneling is removed |
Fig 1 |
| 3 | Align all vehicle lift support points under vehicle jack support points | Only lift vehicle on vehicle jack support points. Otherwise this leads to damage to the longitudinal frame members. |
|
| 4 | Secure vehicle on vehicle lift against falling over | When removing major assemblies e.g. engine, front axle carrier, and axles. | AR00.60-P-0100GZ |
| 5 | Lift vehicle on vehicle lift | ||
| Jack up vehicle | |||
| 6 | Raise vehicle so that wheels are clear of the ground | When using pit lift or floor jack: Only position posts on front axle vehicle jack support point and rear axle vehicle jack support point. Otherwise damage occurs to the body and components. |
|
| 7 | Place jack stands below vehicle jack support points to secure vehicle against tilting and falling down |