Remove/Install Flywheel/Drive Plate - AR03.30-P-8001OGR
Engine 642 in model 166, 292
| Remove | |||
| 1 | Remove transmission with torque converter | Engine 642 in model 292 with transmission 725.0 | AR27.10-P-0500GN |
| Engine 642 in model 166 with transmission 722.9 | AR27.10-P-0500GQ | ||
| 2 | Install retaining lock for crankshaft/starter ring gear) | AR03.30-P-5000OGR | |
| 3 | Detach drive plate from crankshaft | AR03.30-P-8001-02MM | |
| Fig 2 | |||
| Fig 1 | |||
| Install | |||
| 4 | Mount drive plate on crankshaft | AR03.30-P-8001-02MM | |
| *BA03.30-P-1002-01G | |||
| Fig 2 | |||
| Fig 1 | |||
| 5 | Remove retaining lock for crankshaft/starter ring gear | AR03.30-P-5000OGR | |
| 6 | Install transmission with torque converter | Remove/install transmission with torque converter Engine 642 in model 292 with transmission 725.0 | AR27.10-P-0500GN |
| Engine 642 in model 166 with transmission 722.9 | AR27.10-P-0500GQ | ||
| 7 | Perform initialization and encoder adaptation with the diagnostic system | When replacing the clutch plate | |
| AD00.00-P-2000-04A |
FLYWHEEL, DRIVE PLATE, VIBRATION DAMPER, STARTER RING GEAR
| Number | Designation | Engine 642 | ||
|---|---|---|---|---|
| BA03.30-P-1002-01G | Screw/bolt, two-mass flywheel/drive plate to crankshaft | Stage 1 | Nm | 45 |
| Stage 2 | ∠° | 90 | ||