Disconnect Engine Wiring Harness For Removal Of Engine - AR01.00-P-2410-03GQC

Engine 276.8 in model 166, 292 

1. Remove air inlet box upper section on the right (8).
2. Remove prefuse box (11) cover.
3. Open cable duct on suspension strut support fastening console.
4. Detach alternator/starter wiring harness (9) and electric steering wiring harness (10) at prefuse box.
5. Disconnect Electrical connection (12) for electric steering.
6. Unclip wiring harness (9, 10) on fuse box and on longitudinal member reinforcement at the front.
7. Detach ground line for electric steering on longitudinal member reinforcement at the right front.
8. Detach engine ground line at longitudinal member reinforcement at front left.

   Courtesy of MERCEDES-BENZ USA

9. Disconnect electrical connection for electrical wiring harnesses (16, 17) on ME-SFI control unit (N3/10).
10. Disconnect electrical connection from electrical wiring harness (13) on engine.
11. Disconnect electrical connection for transmission wiring harness (15) on engine.
12. Unclip electrical wiring harness (14, 15) on bracket and place to one side.
13. Engine 276.8 in model 292 Unclip electrical lines (13, 14, 15, 17) on bracket for the vacuum pump.

    Courtesy of MERCEDES-BENZ USA

14. Engine 276.8 in model 166 (except 166.063), 292

    Disconnect electrical connections (15a) on transfer case and unclip.

15. Engine 276.8 in model 166.063

    Disconnect and unclip electrical connections at electrical vacuum pump for electrical vacuum pump and electrical A/C compressor and place to one side.

16. Engine 276.8 in model 166.063

    Detach potential line of electrical A/C compressor at longitudinal member reinforcement at the front left and place to one side.

17. Engine 276.8 in model 166.063

    Detach ground line at longitudinal member reinforcement at the front right to the engine and place to one side.

    Courtesy of MERCEDES-BENZ USA