Remove/Install Headlamp Actuation Module - AR82.10-P-4650GQC
Model 166 as of model year 2016 with code 640 (High-performance LED)
Model 166 as of model year 2016 with code 641 (Headlamps, LED, dynamic, left-side traffic)
Model 166 as of model year 2016 with code 642 (Headlamps, LED, dynamic, right-side traffic)
Model 292 with code 640 (High-performance LED)
Model 292 with code 641 (Headlamps, LED, dynamic, left-side traffic)
Model 292 with code 642 (Headlamps, LED, dynamic, right-side traffic)
Fig 1: Left Front Headlamp Unit LED Module Components Location - Model 166 As Of Model Year 2016 With Code 640, 641, 642 (Shown On Model 292)
Shown on model 292
Fig 2: Right Front Headlamp Unit LED Module Components Location - Model 166 As Of Model Year 2016 With Code 640, 641, 642 (Shown On Model 292)
Shown on model 292
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 |
Connect diagnostic system and save basic data from left front lamp unit LED module (2) control unit or right front lamp unit LED module (5) control unit | Only when replacing the left front lamp unit LED module (2) control unit or right front lamp unit LED module (5) control unit. | AD00.00-P-2000-04A |
| 2 | Switch on ignition and store transmitter key outside of transmission range (min. 2 m) | ||
| 3 | Open engine hood and raise to vertical position | ||
| 4 | Open hose bracket (1) and place hoses to one side | When removing the left front lamp unit LED module (2). | |
| 5 | Detach hydraulic fluid container (6) from bracket with lines connected and place to one side | When removing the right front lamp unit LED module (5). | |
| 6 | Remove screws/bolts (3) from left front lamp unit LED module (2) or right front lamp unit LED module (5) | ||
| 7 | Pull out left front lamp unit LED module (2) or right front lamp unit LED module (5) until electrical connectors (4) are accessible | ||
| 8 | Disconnect electrical connections (4) | ||
| 9 | Remove left front lamp unit LED module (2) or right front lamp unit LED module (5) | ||
| 10 | Note series of digits of LAM number | Only when replacing the left front lamp unit LED module (2) control unit or right front lamp unit LED module (5) control unit. | AR82.10-P-4660GQC |
| 11 | Install in the reverse order | ||
| Initial startup | |||
| 12 | Perform SCN coding of left front lamp unit LED module (2) control unit or right front lamp unit LED module (5) control unit | Only when replacing the left front lamp unit LED module (2) control unit or right front lamp unit LED module (5) control unit. | AR54.21-P-0015X |
| 13 |
Transfer previously stored basic data to left front lamp unit LED module (2) control unit or right front lamp unit LED module (5) control unit | Only when replacing the left front lamp unit LED module (2) control unit or right front lamp unit LED module (5) control unit. | AD00.00-P-2000-04A |
| 14 | Perform initial startup of left front lamp unit LED module (2) control unit or right front lamp unit LED module (5) control unit | Only when replacing the left front lamp unit LED module (2) control unit or right front lamp unit LED module (5) control unit. |