LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2017 >> GLS450 >> Repair and Diagnosis >> Body & Frame >> Mirrors >> Interior Equipment - 166 Chassis >> Testing & Repair >> Remove/Install Front Headliner - AR68.30-P-7607GQ

Remove/Install Front Headliner - AR68.30-P-7607GQ

MODEL 166 

with CODE Z05 (B5 armoring on special protection version) 

G14133264Courtesy of MERCEDES-BENZ USA
G14133265Courtesy of MERCEDES-BENZ USA
REMOVINGINSTALLING Remove/install     
1 Remove front overhead control panel   AR82.20-P-1100GQ
2 Remove cover (4) SPECIAL TOOL Mounting wedge Fig 2
3 Release and disconnect electrical connectors (5)    
4 Remove sun visors   AR68.60-P-5480GQ 
5 Remove panelings (4) SPECIAL TOOL Mounting wedge Fig 2
6 Release and disconnect electrical connectors (5)    
7 Remove sun visors   AR68.60-P-5480GQ 
8 Remove paneling from A-pillars   AR68.30-P-4050WX 
9 Remove grab handles   AR68.30-P-4300GQS 
10 Detach upper paneling on B-pillars   AR68.30-P-4700GQ 
11 Remove paneling on C-pillars MODEL 166.0 (except 166.8)
with CODE Z05 (B5 armoring on special protection version)
AR68.30-P-4490GQS
12 Remove partition   AR68.74-P-0651GQS 
13 Remove edge guard in area of roof paneling (1) from body    
14 Move backrest in driver seat and passenger seat down as far as possible    
15 Detach headliner (1) from roof frame and lower NOTES
Helper required! Carefully handle headliner (1), do not kink and lay down on clean base! Otherwise damage and soiling can occur.
IMPORTANT Unclip retaining frame (3) on front overhead control panel on roof frame and detach headliner (1) at front, rear and center from roof frame. Headliner (1) is held by magnets.
 
    SPECIAL TOOL Long wedge Fig 1
16 Remove headliner (1) toward rear from vehicle    
INSPECT Check     
17 Check headliner (1) IMPORTANT Check whether all magnets are present on headliner (1). If loose magnets are present, remove old glue residues. Glue magnets to present positions on headliner (1).  
    2-component adhesive/Devcon 5 Min. Epoxy *BR00.45-Z-1072-02A 
18 Fasten electrical wiring harness to headliner (1) with adhesive tape Only when replacing headliner (1) or electrical wiring harness.  
    Adhesive tape roll, non-woven Tesa tape, 50 meters, 50 mm wide *BR00.45-Z-1144-02A 
19 Install in the reverse order    
Fig 1: Identifying Long Wedge (115 589 03 59 00)
G07070400Courtesy of MERCEDES-BENZ USA
Fig 2: Identifying Mounting Wedge (110 589 03 59 00)
G07079389Courtesy of MERCEDES-BENZ USA
REPAIR MATERIALS

Number Designation Order number
BR00.45-Z-1072-02A 2-component adhesive/Devcon 5 Min. Epoxy A 005 989 09 71
BR00.45-Z-1144-02A Adhesive tape roll, non-woven Tesa tape, 50 meters, 50 mm wide A 008 989 50 85 09