Remove/Install Keyless Go Antenna - AR82.62-P-8000GQ
Model 166, 292
with code 889 (KEYLESS-GO)
MODIFICATION NOTES
| 19.01.2021 | Method for model 166.063 added. | Operation step 2.5 |
Illustrated on model 166.0
Shown on model 166.8
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2.1 | Remove center console. | Model 166.0, 292 with code 889 (KEYLESS-GO) When removing vehicle interior KEYLESS-GO antenna (A2/61). The vehicle interior KEYLESS-GO antenna (A2/61) is located below the ashtray. |
AR68.20-P-2000GQ |
| 2.2 | Remove center console. | Model 166.8 with code 889 (KEYLESS-GO) When removing KEYLESS-GO center console (A2/60). The center console KEYLESS-GO antenna (A2/60) is located below the ashtray. |
AR68.20-P-2000GQ |
| 2.3 | Remove door lining from the rear door. | When removing left rear door KEYLESS-GO antenna (A2/39) or right rear door KEYLESS-GO antenna (A2/41). Model 166 with code 889 (KEYLESS-GO) except code Z04 (Light armoring) except code Z05 (B5 armoring on special protection version) Model 292 with code 889 (KEYLESS-GO) |
AR72.12-P-1010GQ |
| 2.4 | Remove load compartment floor. | Model 166.0 (except 166.063), 292 with code 889 (KEYLESS-GO) When removing trunk KEYLESS-GO antenna (A2/35). |
|
| 2.5 | Remove high-voltage battery module (A100). | Model 166.063 with code 889 (KEYLESS-GO) When removing trunk KEYLESS-GO antenna (A2/35). |
AR54.10-P-1140GQA |
| 2.6 | Release front trunk floor until trunk KEYLESS-GO antenna (A2/35) is accessible. | Model 166.0 (except 166.063), 292 with code 889 (KEYLESS-GO) When removing trunk KEYLESS-GO antenna (A2/35). |
|
| Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating area of mechanical components when moving components. | AS00.00-Z-0009-01A | |
| 2.7 | Fold both rear seats of 2nd seat row forward. | Model 166.8 with code 889 (KEYLESS-GO) When removing vehicle interior KEYLESS-GO antenna (A2/61). |
|
| 2.8 | Remove covers (1, 2) and lift floor covering. | Model 166.8 with code 889 (KEYLESS-GO) When removing vehicle interior KEYLESS-GO antenna (A2/61). |
|
| 3 | Release and disconnect corresponding electrical connector. | ||
| 4 | Remove nuts (4). | Model 166.8 with code 889 (KEYLESS-GO) When removing vehicle interior KEYLESS-GO antenna (A2/61). |
|
| 5 | Unclip corresponding KEYLESS-GO antenna (A2/35, A2/39, A2/41, A2/60 or A2/61). | ||
| 6 | Install in the reverse order. |