Remove/Install Trim Panel At D-Pillar - AR68.30-P-4495GQX

Model 166.8 

MODIFICATION NOTES

13.06.2016

Operation steps and picture added

Operation steps 9, 10, picture P68.30-3932-05

Fig 1: Trim Panel/Cover At D-Pillar Components Location - Model 166.8

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove side paneling in trunk		AR68.30-P-4800GQX
2	Move backrest of third seat row toward front
3	Lift cover (4) and unscrew bolt (2)	Bolt/nut, belt end fitting/seat belt buckle of 3rd seat row to body	*BA91.40-P-1011-01R
4	Remove seat belt (3) from floor
5	Remove airbag cover (9)	Mounting wedge	Fig 2
6	Unscrew bolt (10)
7	Pry off paneling (1) at rear (arrow)	Do not remove sealing weather strip (5) from body. Otherwise it can be damaged and must be replaced.
		Mounting wedge	Fig 2
8	Pull paneling (1) downward and to rear	Guide retaining lug (7) into retaining plate and retaining lug (8) below headliner. Ensure that seal (6) and sealing weatherstrip (5) are seated correctly.
9	Install seat belt (3) and remove paneling (1)
10	Install in the reverse order

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Number	Designation		Model 166
BA91.40-P-1011-01R	Bolt/nut, belt end fitting/seat belt buckle of 3rd seat row to body	Nm	35

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA