Remove/Install 12 Volt Socket - AR54.10-P-1000GQ

MODEL 166 

	Remove/install
1	Switch off ignition
2	Remove center console	When removing center console power outlet (X58/37) Carefully raise center console and place with attached electrical lines on the inside far enough into the rear until the electrical connection of the power outlet (X58/37) is accessible.	AR68.20-P-2000GQ
3	Disconnect electrical connector from center console power outlet (X58/37)	When removing center console power outlet (X58/37) The stowage compartment (1) slider must be closed.
4	Open flap of power outlet (X58/4 or X58/19 or X58/37)
5	Use pliers (2) to release power outlet (X58/4 or X58/19 or X58/37) and pull out of spring pin (4)	The studs of the pliers (2) must mesh into the housing (3) cutouts on the power outlet (X58/4 or X58/19 or X58/37) (arrows). Do not rotate power outlet (X58/4 or X58/19 or X58/37) when removing. Pay attention to correct installation position of power outlet (X58/4 or X58/19 or X58/37).	Figure
			Figure
6	Unclip and remove spring pin (4) by pushing back catch hooks	Pay attention to the correct installation position of the clamping sleeve (4).
7	Detach electrical connection from power outlet (X58/4 or X58/19)	When removing power outlet (X58/4 or X58/19)
8	Install in the reverse order

Fig 1: Identifying Pliers (169 589 00 37 00)

Courtesy of MERCEDES-BENZ USA