Retrofit Cutout In Floor Covering For Incar Hotspot - AZ82.80-P-0002-04GQA

MODEL 166.0 (except 166.074) 

with CODE 386 (Comfort telephony) 

with CODE 527 (COMAND APS with single DVD drive (with navigation)) 

without CODE 460 (Canada version) 

without CODE 494 (US version) 

without CODE 498 (Japanese version) 

without CODE 830 (China version) 

MODEL 166.0 (except 166.074) 

with CODE 386 (Comfort telephony) 

with CODE 512 (COMAND APS with DVD changer) 

without CODE 460 (Canada version) 

without CODE 494 (US version) 

without CODE 498 (Japanese version) 

without CODE 830 (China version) 

1. Draw lines (arrows F and G) parallel to the edge (arrow E) of the floor covering (1) to match dimensions (a and b).

   Dimension (a) and dimension (b) are measured from the edge at the bottom on the rear seat cushion (as shown in the picture).

   Dimension (a) = 180 mm

   Dimension (b) = 300 mm

2. Position measuring tape (2) on left edge of floor covering (1) and align with line (arrow G).
3. Draw line (arrow H) to match dimension (c) at right angle to line (arrow G), as shown.

   Dimension (c) is measured from the left edge of the floor covering (1) (as shown in the picture).

   Dimension (c) = 430 mm

4. Draw end points, as shown, to match dimension (d) on lines (arrows F and G).

   Dimension (d) = 90 mm

5. Slightly raise floor covering (1) and move along the marked cutting edge (arrow S) using a utility knife until the floor covering (1) is separated.
6. Fold back floor covering (1).
7. Press cut out floor covering under the InCar Hotspot (3) (as shown in the picture).
8. Clean floor covering (1).