Prepare Outer Rear Center Section - AR64.20-P-1000-09GQS

MODEL 166.0 with CODE Z04 (Light armoring)

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1001-07A	Zinc dust paint suitable for spot welding, replaced by A 000 986 28 00 1K zinc dust paint	A 000 986 34 42

Cut out sheet metal on left and right sides of center part of rear center section (1).
Cut out sheet metal so that center part of the rear center section is not damaged.
Grind mating surfaces on inner rear center section (1) and center rear center section (2) down to bare metal in crosshatched areas.
Sand down spot weld flanges to bare metal on both sides.
Coat insides of spot weld flanges with zinc dust paint.
Grind mating surfaces on outer rear center section (3) down to bare metal in crosshatched areas.
Sand down spot weld flanges to bare metal on both sides.
Punch holes for (areas A₁ , A₂ ) in outer rear center section.
Use ø 7 mm hole punching pliers.
Coat insides of spot weld flanges with zinc dust paint.