LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2017 >> GLE63 AMG >> Repair and Diagnosis >> Brakes >> Brakes Control Systems >> Brakes - Hydraulic & Mechanical Systems - 166 Chassis - 1 Of 2 >> General Information >> Notes On Installing Brake Wear Indicator Contact Sensors - AH42.10-P-0003-01CW

Notes On Installing Brake Wear Indicator Contact Sensors - AH42.10-P-0003-01CW

MODEL 117, 156, 166, 172, 176, 204, 207, 212, 217, 218, 222, 231, 242, 246, 292, 463 

There is one variant on the front axle:

The following variants exist at the rear axle:

When replacing the brake pads, reinstall the brake pad wear sensor at the same position.

IMPORTANT Route or install the line of the front right brake pad wear sensor (2) or the electrical connector (1) as shown in the picture below.

Shown on front axle on model 204.041 

G11974566

IMPORTANT Route or install the line of the rear right brake pad wear sensor (3) or the electrical connector (4) as shown in the picture below.

Shown on rear axle on model 204.041 

G11974567

For reasons of replacement part simplification, install the brake pads so that the brake pad wear sensors can be reinstalled at the corresponding assembly positions.

The corresponding assembly position of the brake pad wear sensors is specified in the list below.

G07069152

Front axle version 5 

Front axle, version 6 

Rear-axle version 9