Notes On Removing Adhesive Residues And Foils On Paint And Metal Surfaces With Surface Conditioning Disks - AH00.00-P-0013-01AK

MODEL 107, 117, 124, 126, 129, 140, 156, 163, 164, 166, 168, 169, 170, 171, 172, 176, 177, 190, 197, 201, 202, 203, 204, 205, 207, 208, 209, 210, 211, 212, 213, 215, 216, 217, 218, 219, 220, 221, 222, 230, 231, 238, 242, 245, 246, 251, 253, 257, 292, 460, 461, 463 

MODEL 447, 448 

When removing adhesive residue, films, trim elements, etc. using surface conditioning disks, the following points must be observed:

• Use safety glasses and hearing protection.
• Use surface conditioning disk with hand drill.
• Use rotational speed of 2000 rpm to 2500 rpm, to prevent any smearing.
• Apply only light pressure to the repair surface using the surface conditioning disk and do not work on one area for too long. Otherwise, excessive heat development can damage the sheet metal or paint.
• The rotation direction of the surface conditioning disk must be opposite to the working direction.
• When using on water-based coatings, perform preliminary tests at inconspicuous points. Discoloration of the paint may occur in isolated cases.
• Do not use surface conditioning disks on plastics or painted plastic parts, e.g. on a bumper.