Remove/Install Wind Deflector - AR77.20-P-2500EL
MODEL 166.0 with CODE 414 (Power glass tilting/sliding roof)
MODEL 218 with CODE 414 (Power glass tilting/sliding roof)
MODEL 212 as of model year 2012 with CODE 414 (Electric sunroof, glass version)
Shown on left side of vehicle on model 218
| Remove/install | |||
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| 1 | Open tilting/sliding roof | ||
| 2 | Press left holder (2) on outside down with assembly wedge (3), as illustrated, and guide holder (2) out of roof hem | Carefully press bracket (2) down and move out. Can break otherwise. pin (arrow A) on holder (2) is properly seated in opening (arrow B) in roof frame. |
Fig 1 |
| 3 | Press left bracket (2) on outside down with assembly wedge (3), as illustrated, and guide bracket (2) out of roof hem | Carefully press bracket (2) down and move out. Can break otherwise. |
Fig 1 |
| 4 | Remove wind deflector (2) | ||
| 5 | Install in the reverse order | ||
| 6 |
Connect Star Diagnosis, read out fault memory, perform teach-in run for sliding roof anti-pinch protection | AD00.00-P-2000-04A |