Remove/Install Tilting/Sliding Roof Motor - AR77.20-P-3010GZ

MODEL 164, 166 with CODE 414 (Sliding sunroof) 

Shown on model 164.1 

	Remove/install
1	Move sliding roof to tilt position "OPEN"	Up to end position.
2	Unclip front overhead control panel from headliner and allow to hang down with electrical lines	MODEL 164 with CODE 414 (Sliding sunroof) Remove/install front overhead control panel	AR82.20-P-1100GZ
3	Loosen headliner in front area up to B-pillars	MODEL 166 with CODE 414 (Sliding sunroof) with CODE Z05 (B5 armoring on special protection version)	AR68.30-P-4300GQS
	MODEL 166 with CODE 414 (Sliding sunroof) without CODE Z05 (B5 armoring on special protection version)		AR68.30-P-4300GQ
4	Remove bolt (1)	: Replace screws/bolts (1). First position all bolts (1). Then tighten bolts (1) from left to right.
5	Remove sliding roof drive unit (M12)
6	Install in the reverse order
7	Perform teach-in run for automatic reserving function of sliding roof Connect STAR DIAGNOSIS and read out fault memory		AD00.00-P-2000-04A