Adjust Tilting/Sliding Roof Panel - AR77.20-P-1100GZ

MODEL 164, 166 with CODE 414 (Power glass tilting/sliding roof) 

Shown on model 164.1 

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Adjust
1	Move tilting/sliding roof panel (4) into tilt position
2	Remove rubber bellows (1) on left and right from tilting/sliding roof	MODEL 164, 166 with CODE 414 (Power glass tilting/sliding roof) MODEL 164 with CODE 414 (Power glass tilting/sliding roof)	AR77.20-P-1150GZ
3	Close tilting/sliding roof panel (4)
4	Loosen bolts (2) on left and right on tilting/sliding roof panel (4)
5	Insert cardboard strips (3) at rear into expansion joint for tilting/sliding roof panel (4)	Cardboard strip (3): Approx. 500 mm long, approx. 2 mm thick.
6	Adjust tilting/sliding roof panel (4) in relation to exterior roof surface	When adjusting height: Determine measuring positions (crosses) using interval (A).
		MODEL 166 with CODE 414 (Power glass tilting/sliding roof) MODEL 164 with CODE 414 (Power glass tilting/sliding roof)	*BE77.21-P-1001-01E  *BE77.20-P-1001-01E
7	Tighten left and right bolts (2) on tilting/sliding roof panel (4)	Tighten bolts (2) from rear to front.
8	Move tilting/sliding roof panel (4) to tilt position and remove cardboard strips (3)
9	Remove rubber bellows (1) on left and right from tilting/sliding roof	MODEL 164, 166 with CODE 414 (Power glass tilting/sliding roof) MODEL 164 with CODE 414 (Power glass tilting/sliding roof)	AR77.20-P-1150GZ
10	Connect STAR DIAGNOSIS and perform teach-in run for anti-pinch protection for tilting/sliding roof		AD00.00-P-2000-04A