Remove/Install Air Suspension Compressor Holder - AR32.22-P-2009LW

Model 205 with code 489 (AIRMATIC) 

Model 213.0 (except 213.088/089), 213.1 with code 489 (AIRMATIC) 

Model 213.2 (except 213.288/289) 

Model 253 (except 253.388/389/988/989) with code 489 (AIR BODY CONTROL) 

Courtesy of MERCEDES-BENZ USA

Shown on model 205 

Courtesy of MERCEDES-BENZ USA

	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Remove/install
1	Remove AIR BODY CONTROL compressor (A9/1)		AR32.22-P-2001LW
2	Open line bracket (2) and unhook air intake hose (3)
3	Open line bracket (4) and unhook lines
4	Remove AIR BODY CONTROL valve unit from bracket (1) and fix in place on vehicle with lines attached		AR32.22-P-2015LW
5	Remove bolt (5)	Model 205 with code 489 (AIRMATIC) Model 253 (except 253.388/389/988/989) with code 489 (AIR BODY CONTROL) Bolt/nut, bracket for compressor unit to body/cross member	*BA32.22-P-1002-03G
		Model 213.0 (except 213.088/089), 213.1 with code 489 (AIRMATIC) Model 213.2 (except 213.288/289) Bolt/nut, bracket for compressor unit to body/cross member	BA32.22-P-1002-03H
6	Unscrew nut (6)	Model 205 with code 489 (AIRMATIC) Model 253 (except 253.388/389/988/989) with code 489 (AIR BODY CONTROL) Bolt/nut, bracket for compressor unit to body/cross member	*BA32.22-P-1002-03G
		Model 213.0 (except 213.088/089), 213.1 with code 489 (AIRMATIC) Model 213.2 (except 213.288/289) Bolt/nut, bracket for compressor unit to body/cross member	BA32.22-P-1002-03H
7	Loosen nut (7)	Model 205 with code 489 (AIRMATIC) Model 253 (except 253.388/389/988/989) with code 489 (AIR BODY CONTROL) Bolt/nut, bracket for compressor unit to body/cross member	*BA32.22-P-1002-03G
		Model 213.0 (except 213.088/089), 213.1 with code 489 (AIRMATIC) Model 213.2 (except 213.288/289) Bolt/nut, bracket for compressor unit to body/cross member	BA32.22-P-1002-03H
8	Slide bracket (1) backward and remove
9	Remove elastomer bearing (8) and line brackets (2, 4)	When replacing bracket (1).
	Check
10	Check elastomer bearing (8) for hardening and damage	If there are problems ↓ Replace elastomer bearings (8).
11	Install in the reverse order