Remove/Install The Coolant Lines For The Turbocharger - AR09.40-P-6020-14MR
Engine 274
MODIFICATION NOTES
| 18.05.2016 | Screw coolant line supply / return to exhaust gas turbocharger | BA09.40-P-1009-01U | |
| 18.05.2016 | Coolant line screw return to cylinder head | BA09.40-P-1011-01U |
TURBOCHARGER
| Number | Designation | Engine 274 | ||
|---|---|---|---|---|
| BA09.40-P-1009-01U | Bolt, coolant feed/return line to turbocharger | Stage 1 | Nm | 8 |
| Stage 2 | ∠° | 60 | ||
TURBOCHARGER
| Number | Designation | Engine 274 | |
|---|---|---|---|
| BA09.40-P-1010-01U | Bolt, coolant line feed line to water pump | Nm | 9 |
TURBOCHARGER
| Number | Designation | Engine 274 | ||
|---|---|---|---|---|
| BA09.40-P-1011-01U | Bolt, coolant return flow line to cylinder head | Stage 1 | Nm | 8 |
| Stage 2 | ∠° | 60 | ||
- Detach coolant return line (3) at cylinder head and turbocharger.
Installation: Replace screw/bolts.
- Detach coolant return line (4) at coolant pump and turbocharger.
| Remove/install left heat shield on left turbocharger | AR09.40-P-6026-01MNG | ||
| Risk of injury . Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. | AS00.00-Z-0017-01A |
Engine 177 in model 253
TURBOCHARGER
| Number | Designation | Engine 177 | |
|---|---|---|---|
| BA09.40-P-1007-01ZA | Bolt, side heat shield to cylinder head cover | Nm | 9 |
- Remove screw/bolts (2)
.
- Remove heat shield (1) upwards.
- Install in the reverse order.