LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2017 >> GLC300 Base >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Air Intake, Turbocharging - 253 Chassis >> Testing & Repair >> Remove/Install Left Circulation Pump In Engine Compartment For Low-Temperature Circuit - AR09.41-P-6932MNG

Remove/Install Left Circulation Pump In Engine Compartment For Low-Temperature Circuit - AR09.41-P-6932MNG

Engine 177 in model 253 

Fig 1: Low Temperature Circuit Circulation Pump (3/3) (M43/6) Components Location - Engine 177 in Model 253
G12817136Courtesy of MERCEDES-BENZ USA
G12817137Courtesy of MERCEDES-BENZ USA
WARNING Risk of injury  to skin and eyes suffering scalding from contact with hot coolant spray. Risk of poisoning  from swallowing coolant. Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers.
Wear protective gloves, protective clothing and safety glasses.
AS20.00-Z-0001-01A
WARNING Risk of injury  . Skin or eye injuries may result when handling hot or glowing objects. Wear protective gloves, protective clothing and safety glasses, if necessary. AS00.00-Z-0002-01A
CAUTION Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. AS00.00-Z-0017-01A
  Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
  Notes on avoiding damage through contamination and foreign objects   AH00.00-P-5000-01A
REMOVINGINSTALLING Remove/install     
1 Remove fan unit (38)   AR20.40-P-5050MNG
2 Remove coolant hoses (3, 4) from low-temperature circuit circulation pump (M43/8)   AR20.20-P-7441-01RQ
3 Remove low-temperature circuit circulation pump 3 (M43/8) upward    
4 Unscrew nut (6) and take off bracket (7) When replacing low-temperature circuit circulation pump 3 (M43/8).  
    TORQUE SPECIFICATION Nut/screw, low-temperature circuit pump/switchover valve retaining bracket to holder *BA20.10-P-1007-01ZA 
5 Remove low-temperature circuit circulation pump 3 (M43/8) from bracket (5) When replacing low-temperature circuit circulation pump 3 (M43/8).  
6 Install in the reverse order    
COOLANT PUMP, COOLANT THERMOSTAT

Number Designation Engine 177
BA20.10-P-1007-01ZA Nut/screw, low-temperature circuit pump/switchover valve retaining bracket to holder Nm 8