Inductive Charging, Basic Function - GF82.70-P-1000A

Model all (CAR) 

with code 897 (Wireless mobile phone charging) 

Model all (CAR) 

with code 898 (Wireless charging in rear) 

Model all (CAR) 

with code 899 (Multifunction telephony) 

General 

The inductive charging function enables mobile phones to be charged wirelessly.

Function requirement 

• Mobile phone with Qi standard

Function 

The inductive charging of mobile phones occurs via the contact surface of the mobile phone cradle control unit or the rear passenger compartment mobile phone cradle control unit. To do this, the coils integrated into the mobile phone cradle induce electricity in the coils integrated into the mobile phone.

The smartphone exchanges information regarding the charge level via the inductive coupling as well (as parts scope of the Qi standard).

Multimedia system control evaluates the charge level and starts or ends the charging process depending on the charge level of the mobile phone.

Inductive charging is only possible over very short distances. Therefore, as small a distance as possible between the transmitting coil and the receiving coil is important for efficient charging.

Because the position of the coil in the mobile phone can vary depending on the model, the position of the mobile phone in the mobile phone cradle can have an influence on the charging behavior.

For inductive charging, the mobile phone cradle supports Qi standard 1.2. This enables fast charging with up to 15 W of output depending on the mobile phone.

	Control units
	Mobile phone cradle control unit, basic function		GF82.70-P-9890A