Actuate Reversing Light, Basic Function - GF82.10-P-1024A
Model all (CAR)
General
The reversing light lights up the roadway behind the vehicle when reversing.
Function requirement
- Circuit 15 ON (vehicles with manual transmission or electric vehicles)
- Engine running (vehicles with automatic transmission)
Actuate reversing light
When reverse gear or drive range "R" is engaged, the reversing light is switched on.
The exterior lighting control unit (vehicle-specific either the central controller unit or the front central controller unit) actuates the reversing light independently or requests the actuation. This takes place depending on the network architecture of the vehicle.
Vehicles with trailer hitch
During trailer operation, the reversing lights on the trailer are also switched on. The exterior lighting control unit requests actuation of the reversing light on the trailer. The trailer recognition control unit implements this request.
| Function schematics | |||
| Function schematic for detection of transmission position | Model 118, 177, 247, Model 167, Model 293 | PE27.19-P-2500-97A | |
| Function schematic, actuate reversing light | Model 118, 177, 247 | PE82.10-P-2513-97A | |
| Model 167, Model 293 | PE82.10-P-2513-97B | ||
| Control units | |||
| Trailer recognition control unit, basic function | Model all (CAR) with code 550 (Trailer coupling) |
GF31.19-P-9890A | |
| Central controller unit, basic function | Model 118, 177, 247 | GF54.21-P-9895A | |
| Front central controller unit basic function | Model 167 Model 293 |
GF54.21-P-9896A | |
| Components | |||
| Rear lamp unit, basic function | GF82.10-P-2004A |