Remove/install axle shaft radial shaft seals - AR27.40-P-0210NKB
TRANSMISSION 724.0 in MODEL 117
TRANSMISSION 724.0 in MODEL 156
TRANSMISSION 724.0 in MODEL 176
TRANSMISSION 724.0 in MODEL 242
TRANSMISSION 724.0 in MODEL 246
| Notes on automatic transmission | AH27.19-P-0001-01NKB | ||
| Remove/install | |||
| 1 | Remove bottom engine compartment paneling | TRANSMISSION 724.0 with ENGINE 133 when removing the right front axle shaft. | |
| MODEL 117, 156, 176 with ENGINE 133 with TRANSMISSION 724.0 MODEL 117, 156, 242, 246 with ENGINE 270 with TRANSMISSION 724.0 MODEL 156 with ENGINE 651 with TRANSMISSION 724.0 |
AR61.20-P-1105NKB | ||
| MODEL 117, 176, 246 with ENGINE 607 with TRANSMISSION 724.0 MODEL 117, 176, 246 with ENGINE 651 with TRANSMISSION 724.0 |
AR94.30-P-5300NKB | ||
| 2 | Drain transmission oil | ||
| AP27.00-P-2702NK | |||
| 3 | Remove respective front axle shaft | AR33.30-P-0620NKB | |
| 4 | Remove intermediate pipe between catalytic converter at bottom and rear exhaust system | TRANSMISSION 724.0 in MODEL 117, 156, 176 with ENGINE 133 | |
| AR49.10-P-7100MTA | |||
| 5 | Detach heat shield from crankcase and axle shaft bearing housing | When removing the radial shaft sealing ring (1) at right front axle shaft. | |
| 6 | Pry radial shaft sealing ring (1) out of transmission (27) using a suitable tool | Do not damage seat surface of radial shaft sealing ring (1). This ensures that the radial shaft sealing ring (1) remains leaktight and is seated correctly. |
|
| Fig 2 | |||
| Check | |||
| 7 | Check seat cushion of radial shaft sealing ring (1) | Before inserting the new radial shaft sealing ring (1) check the seat surface for damage. This ensures that the radial shaft sealing ring (1) remains leaktight and is seated correctly. |
|
| 8 | Install in the reverse order | ||
| 9 | Check oil level of transmission (27) and correct if necessary | AR27.00-P-0100NKB | |
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 10 | Perform engine test run and check that transmission (27) is not leaking and is functioning correctly |