Retrofit Adaptive Highbeam Assist - AN82.10-P-0010NKX

MODEL 156.### 1# as of 3/1/17 with CODE 476 (Lane keeping assist) with CODE 632 (Headlamps, LED, static, right-side traffic) 

MODEL 156.### 1# as of 3/1/17 with CODE 513 (Speed Limit Assist) with CODE 632 (Headlamps, LED, static, right-side traffic) 

MODEL 156.### 1# up to 2/28/17 with CODE 476 (Lane keeping assist) with CODE 622 (Intelligent Light System) 

MODEL 156.### 1# up to 2/28/17 with CODE 513 (Speed Limit Assist) with CODE 622 (Intelligent Light System) 

MODEL 156.### 2# as of 3/1/17 with CODE 476 (Lane keeping assist) with CODE 631 (Static LED headlamps, left-hand traffic) 

MODEL 156.### 2# as of 3/1/17 with CODE 513 (Speed Limit Assist) with CODE 631 (Static LED headlamps, left-hand traffic) 

MODEL 156.### 2# up to 2/28/17 with CODE 476 (Lane keeping assist) with CODE 621 (Intelligent Light System (left-hand traffic)) 

MODEL 156.### 2# up to 2/28/17 with CODE 513 (Speed Limit Assist) with CODE 621 (Intelligent Light System (left-hand traffic)) 

	Update Vehicle Documentation (VeDoc)
2	Enter special equipment into the online vehicle data card	Code 608 (Adaptive Highbeam Assist)
3	Attach note Adaptive Highbeam Assist retrofitted as per AN82.10-P-0010NKX  under field organization texts to design group 54 and design group 82
4	Connect diagnostic system and select vehicle using FIN
			AD00.00-P-2000-04A
5	Carry out variant coding using software calibration number (SCN)	Central gateway (CGW) Signal acquisition and actuation module (SAM)  Multifunction camera (MFK)  Instrument cluster (KI)  Headlamp (SW)
6	Disconnect diagnostic system
			AD00.00-P-2000-04A
	Check
7	Perform function test	See owner's manual.