Remove/install taillamp - AR82.10-P-4905NKX

MODEL 156 

Shown on right side of vehicle 

Fig 1: Taillamp Remove/Install Components - Shown On Right Side Of Vehicle

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove cover (1)
2	Remove bolt (2)
3	Pull left rear lamp unit (E3) or right rear lamp unit (E4) straight back (arrow A) and out of the guide (5) and the retaining clip (4)	Clean sealing surfaces. Ensure that all the guides are seated correctly. Check seal (6) for damage and replace if necessary.
4	Disconnect electrical connector (3)
5	Install in the reverse order