Remove/install HERMES control unit - AR82.95-P-0019NKA
MODEL 156, 176, 242, 246 with CODE 360 (HERMES UMTS)
MODEL 156, 176, 242, 246 with CODE 362 (HERMES LTE)
Shown on model 156
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Perform initial startup of the HERMES control unit (N112/9) | When replacing the HERMES control unit (N112/9). | |
| AD00.00-P-2000-04A | |||
| 2 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m) | ||
| 3 | Remove rear shelf | ||
| 4.1 | Open left service flap in trunk | Model 156, 242, 246 with code 360 (HERMES UMTS) Model 156, 242, 246 with code 362 (HERMES LTE) |
|
| 4.2 | Remove side paneling in left side of luggage compartment | Model 176 with code 360 (HERMES UMTS) Model 176 with code 362 (HERMES LTE) |
|
| AR68.30-P-4800NKA | |||
| 5 | Release and disconnect electrical connectors (2) from HERMES control unit (N112/9) | ||
| 6 | Unscrew nuts (1) | ||
| 7 | Remove HERMES control unit (N112/9) | ||
| 8 | Install in the reverse order |