Remove/install front stabilizer bar - AR32.35-P-2050BD
MODEL 461
MODEL 463 up to model year 2013/model refinement package 2012
Illustrated on model 463.270
MODIFICATION NOTES
| 11.10.04 | Torque for stabilizer bar mounting clamp to trailing arm changed from 70 Nm to 50 Nm. | *BA32.35-P-1001-01A |
| Remove/install | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| 1 | Raise vehicle | AR00.60-P-1000G | |
| 2 | Detach nuts (2) | *BA32.35-P-1001-01A | |
| 3 | Detach bracket (3) from trailing arm | ||
| 4 | Remove heat shield (4) | ||
| 5 | Loosen bolted connection (5) and remove stabilizer bar (1) with stabilizer bracket (6). | *BA32.35-P-1003-01A | |
| 6 | Detach stabilizer bracket (6) from stabilizer bar (1) | When replacing the stabilizer bar (1). | |
| *BA32.35-P-1002-01A | |||
| 7 | Check rubber mounts for wear and damage and replace if necessary | ||
| 8 | Install in the reverse order |
ANTI-ROLL BAR
| Number | Designation | Model 460, 461, 463 | |
|---|---|---|---|
| BA32.35-P-1001-01A | Nut, anti-roll bar mounting clamp to trailing arm | Nm | 50 |
| BA32.35-P-1002-01A | Nut, stabilizer to stabilizer bracket | Nm | 90 |
| BA32.35-P-1003-01A | Nut, stabilizer bracket to frame | Nm | 90 |