Shock absorber - Checking leaktightness and condition - AP32.25-P-3254G

MODEL 460, 461, 463 

MODIFICATION NOTES

18.3.08	Lift vehicle with vehicle lift, added	Operation step 1
	Lower vehicle, added	Operation step 6

	Checking
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
1	Raise vehicle with vehicle lift
	Lift/jack up vehicle		AR00.60-P-1000G
2	Check seals of piston rods	No oil must escape at the seals. Oil mist in the area of the seals is not significant.
3	Check rubber mounts	The rubber mounts must not be cracked, spongy, swollen or chafed. They must be free of oil and grease.
4	Check shock absorber mountings on front axle and on vehicle frame	Nut, shock absorber to front axle	*BA32.25-P-1001-01D
		Bolt, shock absorber to frame	*BA32.25-P-1002-01D
5	Check shock absorber mountings on rear axle and on vehicle frame	Bolt, shock absorber to rear axle	*BA32.25-P-1001-03E
		Nut, shock absorber to frame	*BA32.25-P-1002-03E
6	Lower vehicle

FRONT AXLE SHOCK ABSORBER

Number	Designation				Model 460, 461, 463
BA32.25-P-1001-01D	Nut, shock absorber to front axle		M12x1.5	Nm	55
			M14x1.5	Nm	70
BA32.25-P-1002-01D	Bolt, shock absorber to frame	Outside diameter of bushing 21 mm	M16x1, 5	Nm	130
		Outside diameter of bushing ≥ 22 mm	M16x1, 5	Nm	170
		-			-

REAR AXLE SHOCK ABSORBER

Number	Designation			Model 460, 461, 463
BA32.25-P-1001-03E	Bolt, shock absorber to rear axle	M16x1.5	Nm	170
BA32.25-P-1002-03E	Nut, shock absorber to frame	M12x1.5	Nm	55
		M14x1.5	Nm	70