LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2017 >> G65 AMG >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Electrical System - Body - 463 Chassis >> Testing & Repair >> Remove/install COMAND APS hard drive >> Remove/install COMAND APS hard drive - AR82.85-P-1001A

Remove/install COMAND APS hard drive - AR82.85-P-1001A

MODEL 164, 169, 171, 211, 219, 230, 245, 251 as of model year 2009 with CODE (512) COMAND APS with DVD changer with CODE (527) COMAND APS with single DVD drive (with navigation) except CODE (498) Japan version 

MODEL 203.7 with CODE (527) COMAND APS with single DVD drive (with navigation) with CODE (044) New Telematics Generation NTG 2.5 except CODE (498) Japan version 

MODEL 463 with CODE (EU1) COMAND APS except CODE (ZJ1) Japan version up to model year 2013/model refinement package 2012 

Fig 1: COMAND APS Hard Drive Remove/Install Components
G10118431Courtesy of MERCEDES-BENZ USA
REMOVINGINSTALLING Remove/install     
NOTES Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
    IMPORTANT The following faults require an exchange of the hard disk (2):
  • System starts only as far as the star symbol and then shuts itself off again
  • Permanent fault messages such as:
    • Navigation unavailable
    • Drive unavailable
  • Music Register nonfunctional
  • Fault code 94D9:
    • Hard disk has malfunction
 
1 Perform initial startup of hard disk (2) at COMAND operating, display and controller unit (A40/3) with STAR DIAGNOSIS When replacing hard disk (2). AD00.00-P-2000-04A
2 Remove the COMAND operating, display and controller unit (A40/3) Model 164 AR82.60-P-7502GZ
Model 169, 245 AR82.85-P-1000AK
Model 171 AR82.85-P-1000V
Model 203.7 AR82.85-P-7472PA
Model 211 AR82.85-P-1000T
Model 219 AR82.60-P-7502TY
Model 230 AR82.85-P-7472RA
Model 251 AR82.60-P-7502RT
MODEL 463 AR82.85-P-7472GY
3 Set down COMAND operating, display and controller unit (A40/3) on an electrostatic discharge (ESD) workstation NOTES Otherwise damage to the electronics of the COMAND operating, display and controller unit (A40/3) or the hard disk (2) may occur.
ESD protection
 
 
4 Remove screws/bolts (1)    
5 Remove hard disk (2) upward (arrow) NOTES Avoid contact of the conductor tracks on the circuit board, otherwise damage to the electronics of the hard disk (2) or the COMAND operating, display and controller unit (A40/3) may occur.  
6 Install in the reverse order    
7 Update map data for navigation system Model 164, 169, 171, 219, 230, 245, 251 up to model year 2011
Model 203.7, 211
 
* Map update
Model 164, 169, 171, 219, 230, 245, 251 as of model year 2011
MODEL 463
AP82.85-P-8250A
8 Perform function test