Deployment Of Airbag Units When No Deployment Device Is Present - AR91.60-P-0611-05A

MODEL 163, 168, 170, 202, 203, 208, 209, 210, 215, 220, 230, 240, 414, 461, 463  

	Risk of injury  caused by performing testing or repair work on airbag or emergency tensioning retractor units.	Model 163, 168, 170, 202 as of 1.7.93, 203, 208, 209, 210, 215, 220, 230, 240, 414, 461 as of 1.4.94, 463 Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply.	AS91.00-Z-0001-01A
	Risk of injury  caused by performing testing or repair work on airbag or emergency tensioning retractor units.	Model 202 up to 30.6.93 Store airbag unit with deployment face up, do not subject to temperatures above 100 °C. When working on these units, disconnect power supply and unplug the SRS test connector (X11/13).	AS91.00-Z-0001-01B
	Notes on controlled deployment of airbag, sidebag and emergency tensioning retractor units		AH91.60-P-0611-02P
	Ignition cable for firing airbag and seat belt tensioner units		WF58.50-P-9160-02A
	Notes on disposing of airbag and emergency tensioning retractor units		OS91.00-P-0001-01A

Use of self-fabricated ignition cable 

1. Fabricate ignition cable with a length of at least 10 m with pressure switch.
2. Plug the 2-pin plug connector into the corresponding airbag unit.
3. Connect ignition cable to battery.
4. Press both pressure switches at the same time.
5. For airbag units with 2 squibs, both must be deployed. To do this, repeat steps 2 to 4 after plugging the ignition cable into the second squib.

Maintain a safe distance of 10 meters.