LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2017 >> G550 >> Repair and Diagnosis >> Accessories & Equipment >> Window Motors & Regulators >> Doors - 463 Chassis >> Testing & Repair >> (Remove/Install Tailgate Door Lock - AR72.20-P-4065G)

(Remove/Install Tailgate Door Lock - AR72.20-P-4065G)

Model 463.200/204/206/207/208/209/250/254/300/303/304/306/307/308/309 

up to model year 2013 

Cabrio 

Model 463.202 

up to model year 2013 

convertible,/facelift 2012 

G13659809Courtesy of MERCEDES-BENZ USA
G13659810Courtesy of MERCEDES-BENZ USA
G13659811Courtesy of MERCEDES-BENZ USA
REMOVINGINSTALLING Remove/install     
  Open liftgate IMPORTANT See owner's manual.  
  Open stowage compartment flap on liftgate IMPORTANT See owner's manual.  
  Remove plastic shell (1) IMPORTANT For this purpose, pry out and remove plastic rivets (2). Unclip expansion anchor (3).  
  Remove retainer (4) at release linkage actuator motor (5) from rear-end door central locking motor (M14/7) IMPORTANT Only in case of liftgate central locking system. Press actuator motor actuation linkage (5) out of the lever (6).  
  Remove return spring (7) from the left locking lug actuation linkage (8) IMPORTANT Only in case of liftgate central locking system.  
  Remove left liftgate locking lug (9) IMPORTANT Unscrew screws (12) and remove threaded plate (11). Pull left liftgate locking lug (9) in the direction of the arrow out of the liftgate. Release the release linkage retainer (10) and remove left liftgate lock element (9).  
  Remove retainer from right locking lug actuation linkage (13) IMPORTANT Press actuation linkage out of the lever (14).  
  Unscrew door lock nuts (15)    
  Remove door lock with left locking lug actuation linkage (8) and remove seal downward INSTALLATION IMPORTANT Check whether the seal touches the door lock correctly. If the seal is not installed correctly, the function of the central locking system on the door lock is not guaranteed.  
  Install in the reverse order INSTALLATION IMPORTANT Compliance with the following operation steps facilitates the installation of the retainers of the release linkage at the door lock.
First, mount actuator motor actuation linkage (5), left locking lug actuation linkage (8), and right locking lug actuation linkage (13) on the door lock, the install door lock. Remove rear-end door central locking motor (M14/7). Attach right lock element release linkage (13) to rear-end door central locking motor (M14/7).
 
  Perform door lock function test IMPORTANT See owner's manual.