Check Battery - AR54.10-P-1129-01A

Model 117, 124, 126, 129, 140, 156, 163, 164, 166, 168, 169, 170, 171, 172, 176, 199, 201, 202, 203, 204, 207, 208, 209, 210, 211, 212, 215, 216, 218, 219, 220, 221, 230, 231, 240, 242, 245, 246, 251, 292, 451, 453, 461, 463 

Model 190 

except code U98 (LITHIUM-ION STARTER BATTERY (LISB)) 

Model 197 

except code P98 (Black Series) 

Model 205 

except code P25 (BlueEFFICIENCY Edition) 

except code U98 (LITHIUM-ION STARTER BATTERY (LISB)) 

Model 213, 238, 253 

except code U98 (LITHIUM-ION STARTER BATTERY (LISB)) 

Model 217 (except 217.37/47) 

Model 222 (except 222.077/176/177/178/179/187/188) 

Model 257 

Model 290 

Model 293 

	Risk of fire  /risk of explosion due to short circuit and escaping oxyhydrogen gas. Risk of (burn) injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte/mist, short circuit and arcing. Risk of poisoning  caused by swallowing battery electrolyte or absorption of lead through the skin or orifices. Risk of death  due to voltage U >= 25V AC and U >= 60V DC.	No fires, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and glasses. Only pour battery acid into suitable and appropriately marked containers.	AS54.10-Z-0001-01A
	Notes on 12V/48V lithium-ion battery	Model 190 except Code U98 (LITHIUM-ION STARTER BATTERY (LISB)) Model 197 except code P98 (Black Series) Model 205 except code P25 (BlueEFFICIENCY Edition) except Code U98 (LITHIUM-ION STARTER BATTERY (LISB)) Model 205 except code P25 (BlueEFFICIENCY Edition) except Code U98 (LITHIUM-ION STARTER BATTERY (LISB)) Model 217 (except 217.37/47) Model 222 (except 222.077/176/177/178/179/187/188) Model 257, 290	AH54.10-P-0004-01A
	Notes on battery		AH54.10-P-0001-01A
	000 588 02 19 00 Battery tester		WS54.00-N-3006B

10.05.2019

Battery capacity 70 Ah VRLA/AGM

BE54.10-P-1010-01A

Number	Designation				Model all (4xWD, CAR, smart)
BE54.10-P-1006-01A	Battery capacity 60 Ah EN VRLA/AGM	Cold cranking amps	As per	A	660

Number	Designation				Model all (4xWD, CAR, smart)
BE54.10-P-1010-01A	Battery capacity 70 Ah EN VRLA/AGM	Cold cranking amps	As per	A	720

Number	Designation				Model all (4xWD, CAR, smart)
BE54.10-P-1012-01A	Battery capacity 80 Ah EN VRLA/AGM	Cold cranking amps	As per	A	800

Number	Designation				Model all (4xWD, CAR, smart)
BE54.10-P-1015-01A	Battery capacity 95 Ah EN VRLA	Cold cranking amps	As per	A	850

Whenever possible, perform the tests with the battery still installed and connected.

If, when testing, the battery tester shows a "Surface voltage detected" message, this indicates an increased voltage.

1. Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).
2. Switch off lighting and audio components.
3. Connect battery tester to battery.

   Do not connect battery tester to jump start or charging terminal point; always connect it directly to the battery.

   Otherwise the test result may be incorrect.

   Once the battery tester has been connected the currently measured battery voltage is displayed.

   For system noise.

   ↓

   Wait for approx. 2 minutes until the bus systems are switched off and the quiescent current is minimized.

4. Conduct test procedure according to battery test device menu navigation.
5. After the test print out the test code displayed and store it safely in a tamperproof manner.