Check Oil Level In Rear Axle Differential, Correct If Necessary - AR35.31-P-0520-08MNE
Model 213.088/089/288/289
REAR AXLE DIFFERENTIAL HOUSING
| Number | Designation | Model 213 | |
|---|---|---|---|
| BA35.31-P-1002-02H | Oil filler screw of rear axle differential | Nm | 50 |
REAR AXLE GEAR
| Number | Designation | Model 213.088/089/288/289 | |
|---|---|---|---|
| BF35.31-P-1003-02C | Filling capacity for rear axle differential with differential lock | Liter | 1, 2 |
| Specification | BB00.40-P-0235-61A | ||
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1046-04A | Loctite 7063 (400 ml) cleaning spray | A 001 986 71 71 09 |
| BR00.45-Z-1061-01A | Sealant, Omnifit 100H (50 g) | A 002 989 23 71 |
Check oil level at room temperature only and not when the rear axle differential (50) is at operating temperature. Otherwise, when the rear axle differential (50) is at operating temperature, required oil could escape.
Cleaning
- Clean area around oil filler screw (50 g).
- Remove and replace oil filler screw (50g).
Check
- Check and correct oil level
With the correct oil level the oil reaches up to the bottom edge of the threaded hole.
If necessary, add oil or drain off oil until the oil only drips out of the threaded hole.
Cleaning
- New oil filler screw (50g) and threaded hole in rear axle differential (50) with cleaning spray.
- Apply one drop of to lower third of thread of oil filler screw (50g).Rear Axle Differential Oil Drain Screw Components Location - Model 213 With Code 700
- Screw oil filler screw (50g) immediately into the rear axle differential (50) and tighten to the specified torque