Remove Pilot Bushing - AR41.10-P-0250-02LW

Model 205, 213, 238, 253 

Measure 

1. Measure and note dimension (a).

   Depending on the flexible disk thickness, the specified press-in dimension may deviate when installing.

   Courtesy of MERCEDES-BENZ USA

   Remove 

2. Knock pilot bushing (10) using flat chisel uniformly onto drive shaft (arrow).

   Courtesy of MERCEDES-BENZ USA

3. mm from the front edge of the pilot bushing (10), drill a hole (0 10 mm) at a right angle through the pilot bushing (10).

   If pilot bushing (10) is seized.

   Courtesy of MERCEDES-BENZ USA

4. Insert suitable drift through hole and pry pilot bushing (10) out of drive shaft using two assembly levers.

   If pilot bushing (10) is seized.

   Courtesy of MERCEDES-BENZ USA