Correcting Center Inclination Angle At Propeller Shaft Intermediate Bearing - AR41.10-P-0086-04LW

Model 205, 213, 238, 253

MODIFICATION NOTES

27.09.2016

Screw, the intermediate shaft bearing on the frame floor

Model 205

BA41.40-P-1001-01H

CHECK VALUES FOR PROPELLER SHAFT ARTICULATION ANGLE

Number	Designation		Model 205 Except AMG	Model 205 AMG
BE41.10-P-1002-01G	Inclination angle of front propeller shaft relative to rear propeller shaft (∠2)	∠°	+0, 00...+1, 00	+0, 10...+0, 50

CHECK VALUES FOR PROPELLER SHAFT ARTICULATION ANGLE

Number	Designation		Model 213 Except AMG	Model 213 AMG
BE41.10-P-1002-01G	Inclination angle of front propeller shaft relative to rear propeller shaft (∠2)	∠°	+0, 00...+1, 00	+0, 10...+0, 50

CHECK VALUES FOR PROPELLER SHAFT ARTICULATION ANGLE

Number	Designation		Model 238	Model 253
BE41.10-P-1002-01G	Inclination angle of front propeller shaft relative to rear propeller shaft (∠2)	∠°	+0, 00...+1, 00	-3, 00...-1, 00

PROPELLER SHAFT INTERMEDIATE BEARING

Number	Designation		Model 205	Model 213
BA41.40-P-1001-01H	Bolt, propeller shaft intermediate bearing to frame floor assembly	Nm	25	25

PROPELLER SHAFT INTERMEDIATE BEARING

Number	Designation		Model 238	Model 253
BA41.40-P-1001-01H	Bolt, propeller shaft intermediate bearing to frame floor assembly	Nm	25	25

Correct inclination angle at the center (∠2).

To correct the inclination angle, install shop-made shims at the propeller shaft intermediate bearing. A 1 mm thick shim changes the inclination angle by approx. 0.17°.

When using shims > 2 mm thick, increase the bolt length by 5 mm.

If a shim > 5 mm thick is required, check the front engine mount and rear engine mount for signs of settling or wear and replace if necessary.

Mark the propeller shaft intermediate bearing.
Apply color markings identifying the position of the propeller shaft intermediate bearing relative to the frame floor assembly, in order to reproduce the plant installation position when installing.
Remove bolt (7a) from propeller shaft intermediate bearing.
Insert shop-made shims between the frame floor assembly and propeller shaft intermediate bearing.
The dimensions for the shims must be taken at the propeller shaft intermediate bearing, see following picture.

Courtesy of MERCEDES-BENZ USA
Tighten screws/bolts (7a) from propeller shaft intermediate bearing .
Example:

Shims (c) between frame floor assembly and propeller shaft intermediate bearing.

Material: steel or aluminum.

Courtesy of MERCEDES-BENZ USA