Correct Articulation Angle On Rear Axle Differential - AR41.10-P-0086-12OLC
Model 213 (except 213.088/089/288/289), 238
| Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A | ||
| 000 588 10 62 00 Support plate | WS26.00-P-3309B | ||
| 000 588 11 62 00 Major assembly mount | WS01.00-P-0092B |
CHECK VALUES FOR PROPELLER SHAFT ARTICULATION ANGLE
| Number | Designation | Model 213 Except AMG | Model 213 AMG | |
|---|---|---|---|---|
| BE41.10-P-1003-01G | Rear inclination angle of rear propeller shaft relative to rear axle differential (∠3) | ∠° | -1, 00...-0, 17 | -1, 00...-0, 40 |
CHECK VALUES FOR PROPELLER SHAFT ARTICULATION ANGLE
| Number | Designation | Model 238 | |
|---|---|---|---|
| BE41.10-P-1003-01G | Rear inclination angle of rear propeller shaft relative to rear axle differential (∠3) | ∠° | -1, 00...-0, 17 |
REAR AXLE CARRIER
| Number | Designation | Model 213 | Model 238 | |||
|---|---|---|---|---|---|---|
| BA35.10-P-1005-01H | Rear axle differential to front adapter | Rear axle differential (steel) | Nm | 65 | - | |
| Rear axle differential (aluminum) | Stage 1 | Nm | 40 | 40 | ||
| Stage 2 | ∠° | 45 | 45 | |||
Correct rear inclination angle ( ∠°)
To correct the articulation angle at the rear axle differential, appropriate spacer washers (arrow) are available as replacement part.
The spacer washers are available in a thickness of 1 mm to 4 mm. Each 1 mm of eccentricity changes the articulation angle by approx. 0.25° to 0.33°.