Install Illuminated Door Sill - AZ82.20-P-0001-01LEW
Model 213.0/2
Installation is shown on the example of the right-hand side of the vehicle. Installation at the left-hand side of the vehicle takes place in the same way.
- Clean contact surface of door sill in the hatched area.
- Remove carrier foil (8) from the right front illuminated door sill molding (E17/48).
Pay attention to guides (9) during subsequent installation.
- Position right front illuminated door sill molding (E17/48) on longitudinal member and press on evenly.
- Connect black 2-pin connector (12) of electrical line for right front illuminated door sill molding (E17/48) to black 2-pin plug (2.9) of right front illuminated door sill molding branch-off line (2.2).
- Clip in created electrical connector at cable duct.
- Route electrical line of right front illuminated door sill molding (E17/48) via body flange on longitudinal member and fix in place with duct tape (10).
- Fix electrical line of right front illuminated door sill molding (E17/48) in place with felt tape (11) at longitudinal member.