Remove/install pressure transducer for boost pressure control - AR07.17-P-7002ELB
ENGINES 157, 278 in MODEL 212, 218
ENGINES 278 in MODEL 207
Fig 1: Identifying Pressure Transducer For Boost Pressure Control Remove/Install Components - Shown On Model 218.373
Shown on model 218.373
| Remove/install | |||
| Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof | Keep body parts and limbs well clear of moving parts. | AS00.00-Z-0011-01A | |
| Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | ||
| 1 | Open engine hood | ||
| 2 | Remove center section of the upper engine cover (1) | ||
| 3 | Detach vacuum lines (2) from boost pressure control pressure transducer (Y77/1) | ||
| 4 | Disconnect electrical connector (3) from boost pressure control pressure transducer (Y77/1) and set aside | ||
| 5 | Remove bolts (4) and boost pressure control pressure transducer (Y77/1) from bracket (5) on intake manifold | *BA09.41-P-1009-01O | |
| 6 | Install in the reverse order | ||
| 7 | Read out fault memory with STAR DIAGNOSIS and erase if necessary | AD00.00-P-2000-04A |
CHARGE AIR PIPE/CHARGE AIR COOLING
| Number | Designation | Engine 157 | Engine 278 | |
|---|---|---|---|---|
| BA09.41-P-1009-01O | Bolt, pressure transducer to bracket | Nm | 7 | 7 |