Remove/install additional fan for COMAND - AR82.85-P-0005EW
MODEL 207 up to 5/31/13 up to model year 2014 with CODE 512 (COMAND APS with DVD changer)
MODEL 207 up to 5/31/13 up to model year 2014 with CODE 527 (COMAND APS with single DVD drive (with navigation))
MODEL 212 up to 4/13/13 up to model year 2014 with CODE 512 (COMAND APS with DVD changer)
MODEL 212 up to 4/13/13 up to model year 2014 with CODE 527 (COMAND APS with single DVD drive (with navigation))
Shown on model 212
Shown on model 212
Shown on model 212
| Remove/install | |||
| 1 | Remove steering column tube module | MODEL 207 | AR54.25-P-2802CW |
| MODEL 212 | AR54.25-P-2802EW | ||
| 2 | Remove left and right trim piece at instrument panel (3) | MODEL 212 | AR68.10-P-1180EW |
| 3 | First release cover (1) at top at pins (12), then release in lower area at catch hooks (13) toward rear and remove | ||
| Figure | |||
| 4 | Unclip steering column tube cover (2) at both ends from instrument panel (3) (arrows) and remove | ||
| 5 | Remove cover (4) below dashboard on left | ||
| 6 | Unscrew bolts (5) and lower steering column tube (6) | ||
| 7 | Unscrew bolt (7) | ||
| 8 | Slightly twist air intake pipe (8) and remove | Ensure that air intake pipe (8) engages completely at COMAND fan motor (M4/13). Otherwise air intake pipe (8) may detach and cause noises. |
|
| 9 | Pull air intake duct (9) out of connection (arrow) | ||
| 10 | Remove air exhaust duct (9) from COMAND fan motor (M4/13) and remove from instrument panel (3) | ||
| 11 | Disconnect radio fan electrical connector (X120) | ||
| 12 | Unscrew screws/bolts (10) until COMAND fan motor (M413) is detached | ||
| 13 | Remove COMAND fan motor (M413) from air conditioner housing (A32) | ||
| 14 | Install in the reverse order |