Remove/Install Front Axle Level Sensors - AR82.10-P-0004LW

Model 205 

Model 213, 238 

Model 253 

Shown on model 205 except code M005 (4MATIC), left side of vehicle 

Fig 1: Front Axle Level Sensors Components Location - Model 213 (Shown On Model 205)

Courtesy of MERCEDES-BENZ USA

	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Remove/install
1	Remove left or right front wheel		AR40.10-P-1102A
2	Release and detach corresponding plug (1)
3	Detach left or right front fender liner in front area and push toward front	Model 205, 253	AR88.10-P-1300LW
		Model 213, 238	AR88.10-P-1300LWE
4	Unscrew nut (2) and unhook the linkage at left front level sensor (B22/8) or right front level sensor (B22/9)	Do not twist left front level sensor (B22/8) or right front level sensor (B22/9). Pay attention to installation position.
5	Remove screws/bolts (3) and remove left front level sensor (B22/8) or right front level sensor (B22/9)
6	Install in the reverse order
	Calibrate
7	Calibrate left front level sensor (B22/8) or right front level sensor (B22/9) using diagnostic system	When replacing left front level sensor (B22/8) or right front level sensor (B22/9).
		Model 205, 213, 253	AD00.00-P-2000-04B
	Check
8	Check headlamp adjustment and if necessary correct	When replacing left front level sensor (B22/8) or right front level sensor (B22/9).
		Model 205, 253	AP82.10-P-8260E
		Model 213, 238	AP82.10-P-8260J