Remove/Install Seal Of Liftgate - AR72.20-P-2121LWT

Model 205.2 

Model 213.2 

Shown on MODEL 205.2 

Fig 1: Seal Of Liftgate Components Location - Model 213.2 (Shown On Model 205.2)

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on sensor system for trunk lid opening/closing	Model 205.2, 213.2 with Code P17 (KEYLESS-GO package)	AH80.61-P-0001-01A
	Remove/install
1	Unclip cover (2) and remove
2.1	Unscrew bolts (3) and remove end stops (4)	Model 205.2
2.2	Unclip retaining clips and remove end stops (4)	Model 213.2
3	Unclip cover (5) and remove
4	Remove seal (1)	: Do not use any lubricant. Otherwise leakage can occur later.
		: Ensure that seal (1) is seated properly.
5	Clean body flange	Cleaner	*BR00.45-Z-1025-04A
6	Install in the reverse order

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1025-04A	Cleaner	A 005 989 19 71