Retrofit Control Unit - AZ82.20-P-0001-05LEW

Model 213.0/1/2 

1. Stick felt tape (6) to upper side of illuminated door sill molding control unit (1).
2. Stick commercially available velcro strips (7) to lower side of illuminated door sill molding control unit (1).

   Courtesy of MERCEDES-BENZ USA

3. Remove footrest (5) and set down in front passenger footwell.
4. Fold non-woven cloth (5.1) at footrest (5) to one side in area of control unit (1).
5. Remove carrier foils from velcro strips of illuminated door sill molding control unit (1).
6. Glue illuminated door sill molding control unit (1) onto footrest (5).
7. Connect black 18-pin connector (2.4) of illuminated door sill molding wiring harness to illuminated door sill molding control unit (1).

   Courtesy of MERCEDES-BENZ USA