Remove/install panoramic roof wind deflector - AR77.21-P-0100NKA
MODEL 117, 156, 176 with CODE 413 (Panoramic glass roof with top sliding roof)
Shown on MODEL 176
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove/install | |||
| 1 | Detach seal (2) in area of cover (4) on panoramic sliding roof frame (11) | ||
| 2 | Release catch hooks (arrows A) from cover (4) with suitable screwdriver (5) (arrow C) and simultaneously unclip cover (4) with extraction (3) (arrows A) upward (arrow C) and remove | ||
| Screen at front on panoramic sliding sunroof changed | MODEL 117 as of 4/1/13, 176 as of 4/1/13 with CODE 413 (Panoramic glass roof with top sliding roof) Carefully unclip cover (4). Otherwise the catch hooks (arrows A) can break off of the cover (4). Otherwise the headliner (9) or wind deflector (1) can be damaged. |
BT77.21-P-0750-01NKA | |
| Fig 4 | |||
| 3 | Unclip wind deflector frame (1.1) from catch hooks (10) on panoramic sliding roof frame (11) | ||
| 4 | Carefully lift left and right lug (arrow B) with suitable screwdriver (5) and unclip wind deflector frame (1.1) toward rear from panoramic roof frame (11) | ||
| 5 | Fold up wind deflector (1) | ||
| 6 | Unclip wind deflector (1) from left and right wind deflector bearing (1.2) (arrow C) and remove | ||
| 7 | Raise left and right wind deflector bearing (1.2) in front area with clip remover (12), push toward front and remove | Fig 3 | |
| 8 | Install in the reverse order | ||
| 9 | Close diagnostic system, synchronize panoramic roof and perform teach-in run for anti-pinch protection for panoramic roof | ||
| AD00.00-P-2000-04A |