Remove/install trim at C-pillar - AR68.30-P-4490NKC

MODEL 117.3 

Shown on left side of vehicle 

Fig 1: C-Pillar Trim Remove/Install Components - Shown On Left Side Of Vehicle

Courtesy of MERCEDES-BENZ USA

	Remove
1	Adjust left and right front seat toward front
2	Remove cover (2) and unscrew nut (3) from belt end fitting
3	Fold over left and right rear seat backrest
4	Detach edge guard (6) in area of paneling (1)
5	Unclip cover (5) and press associated clips together and remove from body	Clip remover	Figure
6	Unclip paneling (1) and remove	Simultaneously guide seat belt (4) through paneling (1).
		Clip remover	Figure
	Install
7	Clip clips and cover (5) into paneling (1)	Clip completely preassembled paneling (1) into body.
8	Position paneling (1) and clip in	Simultaneously guide seat belt (4) through paneling (1).
9	Fasten edge guard (6) in area of paneling (1)
10	Fold over left and right rear seat backrest
11	Tighten nut (3) on belt end fitting and install cover (2)	Nut, rear belt buckle/belt end fitting to body/pivot bearing	*BA91.40-P-1009-01S

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Number	Designation		MODEL 117
BA91.40-P-1009-01S	Nut, rear belt buckle/belt end fitting to body/pivot bearing	Nm	35

Fig 2: Clip Remover (452 589 01 63 00)

Courtesy of MERCEDES-BENZ USA