Remove/install paneling on B-pillar - AR68.30-P-4700NKB

MODEL 117, 156, 176, 242, 246

Shown on right side of vehicle on MODEL 246

Fig 1: B-Pillar Paneling Remove/Install Components - Shown On Model 246

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove front and rear door sill moldings		AR68.30-P-4100NKB
2	Loosen edge guard (2) in area of upper B-pillar trim (1) and lower B-pillar trim (1.1)
3	Remove bolt (3) from belt end fitting on seat belt (4)	Bolt for belt end fitting on B-pillar	*BA91.40-P-1004-01S
4	Unclip upper B-pillar paneling (1), lift slightly and remove downward	Guide seat belt (4) out of upper B-pillar paneling (1). Ensure that belt height adjuster is seated correctly.
4		Clip remover	Figure
5	Unclip upper B-pillar paneling (1.1), lift slightly and remove downward	Clip remover	Figure
6	Install in the reverse order

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Number	Designation		MODEL 117	MODEL 156
BA91.40-P-1004-01S	Bolt for belt end fitting on B-pillar	Nm	35	35

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Number	Designation		MODEL 176, 242, 246
BA91.40-P-1004-01S	Bolt for belt end fitting on B-pillar	Nm	35

Fig 2: Clip Remover (452 589 01 63 00)

Courtesy of MERCEDES-BENZ USA